These "Wedge" mounts are specifically designed for the Phoenix PHX series Bow. These mounts are designed to rotate the mount base to put the GPS/Sonar screens in line with the Trolling Motor Pedal and sitting the screens Level.
No Pictures available at this time, Refer to L / Icon Series (2018+) Single Wedge Bow Mount for what this mount would look Like.
| Disclaimer: The 2020+ Phoenix Elite and newer PHX with fiberglass Shroud (10" x 16" Plate Type A, D, G, H), The Factory Bow Plate has NO set hole pattern for us to use to put holes in our main plate for mounting, so until Phoenix standardizes the mounting hole pattern, BBT will not put these holes in our plates. You will need to lay your factory plate or Dual Fiberglass shroud on top of our plate and mark your hole pattern in our plate and drill holes to match your Bow pattern. Make sure that the holes are marked from the top side so it will match your hole pattern in your Boat. You will use the Factory screws to mount the main plate back in place. |
These "Wedge" mounts are specifically designed for the Phoenix PHX and 721 / 818 Pro XP series Bow. These mounts are designed to rotate the mount base to put the GPS/Sonar screens in line with the Trolling Motor Pedal and sitting the screens Level.
**Backer plate included**
THERE ARE 4 DIFFERENT PLATE SIZES
(**Plate D & G are same size**)
Plate Sizes
-
Phoenix 721 PRO XP & PHX (2017-2018+)
Bow Type B -
Phoenix 721 PRO XP & PHX (2017-2018+) Bow Type D -
Some Phoenix 818 Pro Model (2021+)
Bow Type E -
Phoenix 721 PRO XP & PHX (2017-2018+)
Bow Type F -
Phoenix 721 PRO XP & PHX (2017-2018+)
Bow Type G
Starting at $355.00
