3 SCREW STEERING WHEEL INSTALLATION INSTRUCTIONS

1. REMOVE THE 3 ALLEN HEAD SCREWS OUT OF THE STEERING WHEEL CAP.
2. INSTALL THE SPACER WITH THE “RIDGE” ON ONE END OF THE SPACER FACING INTO YOUR CURRENT STEERING COG.
3. ALIGN THE 3 SCREW HOLES AND BE SURE THE CONCAVED SLOTS LINE UP WITH YOUR CURRENT STEERING COG SLOTS.
4. INSTALL THE 3 SCREWS SUPPLIED THRU YOUR STEERING WHEEL CAP, THEN THRU THE STEERING SPACER, JUST TIGHTEN ENOUGH TO HOLD EVERTHING IN PLACE.
5. TAKE THE 3 SCREWS OUT THAT ARE HOLDING YOUR STEERING WHEEL ON THE FACTORY STEERING COG.
6. PULL THE STEERING WHEEL OUTWARDS INTO THE SPACER SLOTS AND ALIGN WITH THE OUTSIDE HOLES.
7. PUT YOUR FACTORY 3 SCREWS BACK IN THE STEERING WHEEL.
8. PLACE THE 3 SHORTER SCREWS IN THE HOLES WHERE YOUR STEERING WHEEL WAS.
9. TIGHTEN THE 3 SCREW IN THE CAP.

PARTS TO SEND 

 1 -F114 SPACER

 3 - 65MM LONG X 6MM THREAD SHC SCREWS

 3 - 14MM LONG X 6MM THREAD SHC SCREWS