2017 + RT Models - Ranger changed the steering wheel to a 1 piece Steering Wheel/ Cog. If yours boat has Hydraulic Steering, then your steering wheel should measure from the dash to the inside top edge of steering wheel, it should read about 6 3/8 - 6 5/8", If that is the case, then no spacer should be needed in most cases. If it is 4" on that measurement, then you will need a complete changeover kit to be able to add a spacer to increase area between steering wheel and unit. Steering Wheel Changeover Kit can be purchased here.
These Mounts are Designed to Secure the Larger GPS/Sonar Units.
RT178 / RT188 / RT198 - Dual MEGA Mount (Moving Gauges)
This mount allows you to move your 2 - small gauges down to bottom of mount plate to be able see them and kit includes 2 - snap-in small gauge hole covers
2016 and Earlier RT Models - Your Steering wheel should have 6 screws that hold it in place. A 2 1/2" Steering Wheel spacer will be required for this mount system, which can be purchased here.
You will need to contact Bass Boat Technologies for all other units to be mounted.
Please note: If you have a current sonar/gps unit mounted in the dash, please list in the box below. If there was no unit mounted in dash, please write "none".
If you have smaller units that are not listed in the drop down menu for GPS/Sonar, then go to the RT178 / RT188 / RT198 - Dual Mount (Moving Gauges)